Reset Arduino Programmatically
Using Piezo Sensors to Detect Vibration In this tutorial, you will learn how to use a Piezo sensor to detect vibration. We intend to use this function as part of a larger project involving the use of sensors in public spaces to turn on background music and trigger pre-recorded sounds when people pass through the space.
To keep things simple, however, this tutorial will stick to the simpler concept of the film sensor perceiving vibration.
INGREDIENTS:
• Arduino UNO
• Solderable breadboard
• (1) LM358 OpAmp Integrated Circuit
• (1) Piezo sensors
• (1) Potentiometers
• (1) 1 mega-ohm resistor
• (1) Zener 5.1V 1 Watt diode
• (1) 0.1 uF capacitor
• Jumper
wires
The first step is to put your circuit together. The image below shows the completed circuit using a solderable breadboard. In the bottom left of the image the green and yellow wires are coming from the piezo element. The yellow is the ground, the green is the positive output. A resistor is used for the component. To prevent voltage spikes, a diode is added in parallel to protect other parts of the circuit. The signal is taken into the op amp. The op amp amplifies the signal from the piezo element, and sends that signal from one side of the op amp to the other. The right side of the op amp receives the signal, and is used for amplification of the signal. The left side gets the amplified signal from the right side, and is used for a comparator, determining which values to designate as high or low. The potentiometer adjusts the sensitivity of the comparator, and thus the sensitivity of the trigger. The output of the comparator provides the input for the arduino. Using our code, this input determines the display in the serial monitor, either “EARTHQUAKE” when motion is detected, (a HIGH reading) or “CHILLIN” when motion is not detected (a LOW reading).
This diagram illustrates the flow of the signal through the circuit:
The completed code and serial monitor display look like this:
Arduino Code:
#define VIBRATION_DIGITAL_IN_PIN 8
#define BUZZER_DIGITAL_OUT_PIN 13
int buzzerDurationMillis = 1000;
void setup(){
pinMode(VIBRATION_DIGITAL_IN_PIN, INPUT);
Serial.begin(9600);
}
void loop(){
if(digitalRead(VIBRATION_DIGITAL_IN_PIN) == HIGH){
Serial.println("CHILLIN");
}
else(digitalRead(VIBRATION_DIGITAL_IN_PIN) == LOW);{
Serial.println("EARTHQUAKE");
}
delay(1000);
}
Related Post
